Kodak I3400 Manuel d'utilisateur télécharger pdf (Page 25)

4-6 A-61778 September 2012

Problem solving Use the list below as a guide to check possible solutions to problems you may

encounter when using the printer.

Problem Possible Solution

Print quality is poor or inconsistent

• Be sure the ink cartridge is not empty.

• Be sure the ink cartridge is properly installed.

• Be sure the ink cartridge is in the correct position for printing.

• Verify that the printer has been enabled in the scanning application and

that the expected print string has been specified.

• Verify that all printer connectors are securely fastened and that the

printer cable is securely attached.

• Clean the print head (see “Printing problems when starting up due to

dry print head” below).

Printing problems when starting up

due to dry print head

Remove the ink cartridge from the printer carrier and using a damp cloth

or swab, dab (do not wipe) the ink jets on the ink cartridge, replace the

ink cartridge and try again.

Not printing

• Be sure that printing is enabled in the scanning application.

• Check to be sure that the ink cartridge/printer carrier is secure and in

the desired print position.

• Be sure the tape is removed from the print head.

U2 is displayed in the operator

control panel when trying to print

• Printer Accessory or ink cartridge is not installed.

Ink is being sprayed on the back of

the scanner

• Verify that the printer carrier is securely in a print position (see the

section entitled, “Changing print positions” earlier in this chapter).

Printer door will not close

• Verify that the printer carrier is in the “printing” position.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 46 47

Pas de commentaire

Kodak I3400 Manuel d'utilisateur Page 25