Kodak I3400 Manuel d'utilisateur télécharger pdf (Page 36)

A-61771 September 2012 5-11

Replacing the pre-

separation pad

Change the pre-separation pad when the frequency of multi-fed documents

increases.

1. Open the scanner cover.

2. Remove the pre-separation pad by lifting the pad up and out of position.

3. Install the new pre-separation pad. Be sure it snaps into place.

4. Close the scanner cover.

Replacing the background

strip(s)

In the rare case that you may need to replace the background strip(s), follow

the procedures below.

1. Open the scanner cover.

2. Lift the tab on the left side of the upper background strip and slide the

background strip to the left while lifting it out of position.

3. Insert the new background strip by aligning the tabs with the slots and slide

it to the right until it snaps into place.

4. Repeat Steps 2 and 3 to replace the lower background strip.

5. Close the scanner cover.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 46 47

Pas de commentaire

Kodak I3400 Manuel d'utilisateur Page 36