Kodak I3400 Manuel d'utilisateur télécharger pdf (Page 32)

A-61771 September 2012 5-7

Replacement

procedures

This section provides procedures for replacing the following parts. Use the list

below as a guideline for frequency of replacement.

• Feed module tires and separation roller tires — tire life will vary

depending upon paper types, environment and cleanliness. Nominal tire

life is approximately 500,000 documents; results will vary. Degradation of

feeder performance, multiple feeds, stoppages, etc. indicate a need to

change tires.

• Feed module and separation roller — it is recommended that you install

a new feed module and separation roller every 4th tire change. Install a

new feed module and separation roller at the same time.

• Pre-separation pad — it is recommended that you change the pre-

separation pad at least as often as you change the feed module/separation

roller tires.

• Front transport roller — depending on paper types, environment and

cleanliness, roller life is approximately 1,000,000 documents; results will

vary.

Replacing the feed module

or feed module tires

1. Open the scanner cover.

2. Push the feed module release lever to the right and release the feed

module.

3. If you are just replacing the feed module, go to Step 10. If you are replacing

the tires, proceed with Step 4.

4. With one hand, press the locking tabs (one on each side) while holding the

lower housing with the other hand. Pull the upper housing up and away

from the rollers.

5. Remove both core assemblies.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 46 47

Pas de commentaire

Kodak I3400 Manuel d'utilisateur Page 32