Kodak V600 Zoom Manuel d'utilisateur télécharger pdf (Page 24)

KODAK V600 Digital Projector and KODAK V600 Zoom Digital Projector

Maintenance

Changing the Lamp Module

Important:The lamp in the KODAK V600 Digital Projector and the

KODAK V600 Zoom Digital Projector contains trace

amounts of mercury. Some governments require special

disposal of lamps containing mercury. Dispose of lamps in

accordance with the law and any applicable local

regulations.

The lamp module should be replaced with a certified replacement

part. To order a new lamp, contact your local dealer of KODAK

products or visit our Web site at www.kodak.com/go/projectors

After you have changed the lamp module, make sure that you reset

the lamp counter. See “To reset lamp hours” on page 17.

Warning: When replacing the lamp, be sure to turn off the power and

unplug the power cord. To avoid burns, wait 30 minutes before

opening the lamp module door.

Warning: When you open the lamp module door, be careful to not

touch the hot surfaces inside.

Warning: Do not loosen or remove any screws other than those on

the lamp module door and the lamp module. Doing so may result in

electric shock.

To replace the lamp module:

1. Turn off the projector and let the projector cool for at least 30

minutes.

The fan continues to run after the projector has been turned off.

2. Unplug the power cord from the projector.

3. Turn the projector upside down. With a flat head screw driver,

loosen but do not remove the slotted screw in the lamp module

door.

V600UserGuide.book Page 20 Tuesday, March 21, 2000 8:26 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Pas de commentaire

Kodak V600 Zoom Manuel d'utilisateur Page 24