Kodak Z5120 Manuel d'utilisateur télécharger pdf (Page 58)

50 www.kodak.com/go/support

11 Using an Eye-Fi Card

This chapter pertains only if you’re using an Eye-Fi Card.

An Eye-Fi Card stores pictures just like an SD/SDHC Card does. It also has a built-in

Wi-Fi antenna that uses your Wi-Fi network to transfer pictures from your camera to

your computer or mobile device.

IMPORTANT:

Choose an Eye-Fi X2 Card or higher with a firmware version of 4.5174 or

higher. (View and update firmware using the Eye-Fi Center Software that

accompanies the card.)

Storing pictures on an Eye-Fi Card

To set up and use the Eye-Fi Card and Eye-Fi Center Software, follow the

documentation that accompanies the card. For further Eye-Fi support, see page 51.

CAUTION:

If you’re using an Eye-Fi Card in this camera, it’s critical that you

disable (do not turn on) Endless Memory Mode in Eye-Fi Center

Software.

1 Turn off the camera, then open the door.

2 Insert a card until it clicks into place.

To remove a card, press and release it.

NOTE: When you turn on the camera, it checks to see if a card is inserted. If pictures/videos are detected in

internal memory, the camera prompts you to move them to the card. New pictures/videos are stored

on the card.

Purchase Eye-Fi cards www.eye.fi

Get support for Eye-Fi Cards and Software support.eye.fi

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 79 80

Pas de commentaire

Kodak Z5120 Manuel d'utilisateur Page 58