Kodak Document Scanner 9500 with/without Image Manager 9500 Manuel d'utilisateur Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 101
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
5-6 A-61124 March 1999
SCSI conformance
The scanner conforms to the SCSI specifications as follows:
Single-ended, 8-bit bus, Cable A, shielded connector
(Alternative 2). Cable B is not supported.
Single-initiator (one host) is supported. Disconnect and
Reselect are not supported.
Asynchronous maximum transfer rate of 1.2 M Bytes per
second.
Linked commands and command queuing are not supported.
Programmable target ID dip switch is factory set to 1.
RST signal reset is only monitored. See the hard reset
alternative in SCSI Specifications (Section 5.2.2.1).
The scanner supports Unit Attention condition following
power-up, SCSI bus device reset command or hard reset.
Refer to Section 6.13 of SCSI Specifications.
The scanner operates as a target.
The internal SCSI cable consumes 5 feet (1.5 meters) of the
maximum cable length allowed (19.7 feet/6 meters).
The scanner provides termination power.
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 100 101

Commentaires sur ces manuels

Pas de commentaire