Kodak EasyShare Camera Dock 6000 Manuel d'utilisateur télécharger pdf (Page 14)

Chapter 1

Installing the Camera Insert

The printer dock comes with a universal camera insert installed, which is used

to fit the camera to the printer dock. The universal insert is used with most

cameras.

If your camera comes with a custom insert, use that one instead of the

universal insert. Do not discard the universal insert.

1 To remove the universal insert:

a Push the insert towards the front of the

printer and lift up the back edge.

b Push the insert towards the rear of the

printer and lift out the front edge.

2 To Install the custom insert (included with

your camera) See your camera manual.

a Place the front tabs on the insert in the

slots in the printer dock.

b Fit the back of the insert down into the

dock and snap the insert into place.

NOTE: To order a custom insert for your camera, visit our Web site at

www.kodak.com/go/accessories.

urg_00041.book Page 4 Friday, January 3, 2003 10:37 AM

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Pas de commentaire

Kodak EasyShare Camera Dock 6000 Manuel d'utilisateur Page 14